Julet/HIGO Mini Connector Specs
Introduction#
This note collects the specifications, pinout and dimensions of the Julet/HIGO Mini B signal connector, for anyone who repairs or modifies e-bike wiring.
The Mini B is an overmoulded signal connector that many e-mobility manufacturers use for throttles, e-brakes, PAS sensors and lights. Compatible versions are made by Julet, HIGO and Cusmade, among others. They aren’t available as solderable inline connectors that anyone can fit. They come as prefabricated OEM harnesses, which limits their use in DIY projects.
The waterproofing makes the contact reliable, but you can’t measure the voltage on the pins while the system is connected. If a pin breaks off because the connectors were pushed together the wrong way, it can’t be repaired.
Specifications#
The specifications vary slightly between manufacturers (see the sources below), so the table lists the lowest common values. Don’t run the connectors at these limits.
| Characteristic | Value |
|---|---|
| Rated Voltage | 48 V AC/DC |
| Rated Current | 2 A |
| Withstanding Voltage | 500 V |
| Insulation Resistance | ≥20 MΩ |
| Contact Resistance | ≤10 mΩ |
| Mating Type | Insertion Force 80 N max., Extraction Force 30 N min. |
| Mating Cycles | 200x |
| Operation Temperature | -25 ℃ ~ +80 ℃ |
| Protection Degree | IP67 |
| Max Outer Wire Diameter | 9 mm |
| Mating Length | 62 mm |
| Contact Material | Copper alloy plated with gold |
| Wire Section | 0.14 mm² / 0.20 mm² |
Pinout#

Dimensions#

Sources#
Manufacturer product pages, archived by the Wayback Machine: