Factory Reset an APC AP9631 UPS Network Management Card

updated 2 min read #tutorial #hardware

This note describes two reset procedures for the APC AP9631 Network Management Card 2 (NMC) that work without the special serial cable. It is for owners of a second-hand card who don’t know its password or settings.

Note (2026): APC (Schneider Electric) discontinued the AP9631 in September 2022, and its end of service was June 2024. Its successor is the AP9641 Network Management Card 3 (NMC3). The procedures below were tested on the AP9631 only.

As a new owner of an AP9631, I found two reset procedures that the manual I had didn’t describe. I bought the card for my APC Smart-UPS 750 (SMT750I), and the manual didn’t explain how to reset the card without a special stereo-jack serial cable.

After some experimenting, I found two reset modes:

  • Resetting the admin password: Hold the reset button for 5 seconds, then press it again when the status LED blinks. This resets the admin password, which helps if you have forgotten it or bought the card second-hand.

  • Restoring factory defaults (DHCP mode): Hold the reset button for 20 seconds, then press it again when the status LED starts flashing rapidly. This erases all settings, restores the factory defaults and switches the card to DHCP.

The same procedures may work on other cards of the NMC2 series, which generally reset in a similar way, but I haven’t tested them.

Result#

Both resets only need physical access to the card’s reset button, no special cable. The flip side: anyone who can reach the card can reset it, so keep the UPS somewhere only trusted people can get to.

Sources#

cd ~/writing