Zyxel GS1200-5/8 stuck in upgrade mode
This note shows how I got a Zyxel GS1200 switch out of a failed firmware upgrade by uploading the firmware with curl instead of the web interface.
I tried to upgrade a brand-new GS1200-5 from firmware V2.00(ABKM.1)C0 to V2.00(ABKM.2)C0, using Firefox on Linux.
After I clicked the upgrade button, the switch port LED flashed rapidly, but the upgrade failed when a 30-second timer ran out.
Cancelling the upgrade rebooted the switch, but the web interface stayed stuck in firmware upgrade mode.
A reset and a power cycle didn’t change anything.
In the end, I looked at the page source and used curl to upload the firmware:
curl -F 'firmware=<firmware.bin' --output curl.out 'http://192.168.1.3/httpupg.cgi?cmd=fw_upgrade'
-F sends a multipart/form-data POST, like a submitted web form, with the form field firmware that the upgrade page uses.
The < before the file name tells curl to read the file’s contents into that field as a plain text field.
With @ instead, curl would attach the file as a file upload, including its file name.
Because < sends no file name, renaming the file to firmware.bin beforehand, as I did, wasn’t necessary.
--output curl.out writes the response to a file; otherwise curl refuses to print binary output to the terminal.
Result#
The upload took longer than 30 seconds, but it went through, and the switch came back up with the new firmware and a normal web interface. I suspect the timeout in the web page’s code is simply too short for this upload.
Sources#
- curl manual,
-F, --form(difference between@and<) and binary output prevention: https://curl.se/docs/manpage.html - Zyxel GS1200 series: https://www.zyxel.com/global/en/products/switch/5-8-port-web-managed-gigabit-switch-gs1200-series